Audio buffer
Your Cloud OBS keeps a small margin of sound before it plays your stream key’s feed. More margin rides out the hiccups of a mobile or data connection better, but picture and sound arrive a little later, both at the same time.
Where it is
Section titled “Where it is”Side menu → OBS Servers → click on your server. On its page (with the server on, in the OBS control tab) you’ll find the Audio buffer card, with two options: Automatic (recommended) and Manual.
Automatic (recommended)
Section titled “Automatic (recommended)”It’s the factory setting and the one you want almost every time:
- It starts with the lowest delay, around 200 ms.
- When your connection hiccups, it raises the margin on its own, never above 1.2 seconds.
- When the connection settles, it brings it back down little by little, over a few minutes.
- If the feed stalls for more than a second, it doesn’t pile up that delay: it skips what fell behind and goes back to live. That bit is lost, but your stream doesn’t stay delayed for the rest of the broadcast.
You don’t have to touch anything: it adapts to each stretch of your route.
Manual
Section titled “Manual”With Manual you set the margin yourself in the Margin (ms) field, between 60 and 3000 ms. It always stays the same, even when the connection is fine.
Switch to manual if:
- With automatic, the sound still keeps cutting out. Try
1000. - You’d rather have a fixed, predictable delay.
More margin means more delay: with 3000, your stream runs about 3 seconds further behind than at
the minimum. Go up a little at a time and keep the lowest value that works for you.
When you save
Section titled “When you save”- With the server on, your stream key’s feed drops for a few seconds while it reopens with the
new margin. If you’re live, do it at a quiet moment or switch to your break scene (
Privacy) first. - With the server off, it’s saved and applied the next time you turn it on.
If the sound keeps cutting out
Section titled “If the sound keeps cutting out”- Check your sender’s connection first. On the dashboard, next to your Current bitrate, you get the RTT and packet loss with their traffic light. If it’s red, the problem is coverage: lower your encoder’s bitrate before touching anything else. See The bitrate keeps bouncing or the picture stutters.
- If the connection looks fine and it still cuts out, switch to Manual with
1000in Margin (ms), save and do a short test. - If nothing changes, open a ticket from Support in the dashboard. Tell us your encoder, the protocol and roughly what time it happened: with that we can look at what reached us.
Next step
Section titled “Next step”- Your stream key’s source in OBS — where your feed comes into the Cloud OBS.
- Choosing a protocol — SRT and SRTLA absorb coverage dips better than RTMP.

